Goliath: Todd’s Custom Billet 2010 Polaris Ranger Crew Build

Polaris RANGER Crew Goliath

December 2009 custom-build report: At the 2009 Dirt & Sand and Swap in Phoenix Todd’s Custom Billet unveiled their latest creation named “Goliath.”

A modified 2010 Ranger 800 Crew

They started with a brand new, six passenger, 2010 Polaris RANGER 800 CREW and gutted it down to the frame. Then they upgraded the suspension by adding their 7+” chromoly Long Travel with Elka Shocks with reservoirs.

The build report listed 20-inch wheels, 35-inch tires and more than 21 inches of ground clearance. These are builder-reported figures for the custom vehicle.

Three-row custom seating and bodywork

To gain room for the third row of seating, they removed the stock bed and cage and installed a custom full cage with a wrapped around rear panel to accommodate all 3 rows totaling seating for nine and a clean sharp look.

To set off the front end, they added a custom front bumper that has tabs to hold the two 7″ HIDs which really improve night visibility.

For paint they turned to the guys at CR Designs for the vibrant pearl white body and matching rear panels. The cage, suspension and bumper were powder coated a beautiful Lollipop Candy Red that really set off the pearl white paint. The custom suspension bench, bucket seats with adjustable headrests and built in billet cup holders are TCB edition seats crafted by Triple XXX.

Other items shown are aluminum billet speedo bezel, steering wheel and gas cap, which are all machined in house.

Historical show build

The original report claimed a top speed above 50 mph, without supplying a test method. Its nine-seat layout describes a custom conversion, not Polaris’ factory seating or payload rating. The article does not establish approval for transporting nine occupants.